It's Monday and I started workin on the exhaust and air inlet vent. I completed the inlet by installing a 2 inch x 11 inch square HVAC adjust floor & wall register.
Then cut a 6 inch round hole in the roof for flue.
Then I just could wait any longer to see how this rocket would fly so I lit the burner! [smilie=a_yumdumdoodledum.gif]
Now I know later on the flue height will make things act differ from today, but it was a pretty smooth test run.
Had to damper down the flue hole, but once she warmed up, she ran 165 to 175 degrees nice and slow on a low setting
Still got plenty to do before she really ready, but things are lookin good.
Any advice?